SGT Rock
04-08-2005, 21:24
I posted this at my site, but since we have a more eclectic group over here and there might be someone with the answer I decided to post here too...
I've been using the test Pentagon stove that is made from aluminum for a few days now. I've put it through some big fires - much bigger than you would need to boil two cups of water. After all this it isn't showing any signs of warping or fatigue.
It's 22 gage aluminum sheet you can get at Lowe's for about $4. I'm just wondering if I am making a big mistake if I recommend this material for the DIY builder. It certainly is a lot cheaper and easier to work with than the same amount of Ti.
http://hikinghq.net/ionstove/images/100_0343.jpg
http://hikinghq.net/ionstove/images/100_0345.jpg
I've also found that fanning the fire is a lot easier than using a blow tube.
Anyway, are there any experts than can tell me how much heat this sort of stuff can take?
I've been using the test Pentagon stove that is made from aluminum for a few days now. I've put it through some big fires - much bigger than you would need to boil two cups of water. After all this it isn't showing any signs of warping or fatigue.
It's 22 gage aluminum sheet you can get at Lowe's for about $4. I'm just wondering if I am making a big mistake if I recommend this material for the DIY builder. It certainly is a lot cheaper and easier to work with than the same amount of Ti.
http://hikinghq.net/ionstove/images/100_0343.jpg
http://hikinghq.net/ionstove/images/100_0345.jpg
I've also found that fanning the fire is a lot easier than using a blow tube.
Anyway, are there any experts than can tell me how much heat this sort of stuff can take?