Looking for lightweight pot stand and wind breaker for my alcohol Starlyte burner and Titan MSR .83 pot and smaller pots. What do you all use? Thanks
Looking for lightweight pot stand and wind breaker for my alcohol Starlyte burner and Titan MSR .83 pot and smaller pots. What do you all use? Thanks
Same burner as you ,had him put a bead on my 750 pot it rests on the bead on a ti windscreen. Mostly use Esbit.
Love this kit.
thom
I've made them with 5mil (.005") Ti sheet for use with Starlyte and Esbit.
A simple dovetail tab fits into the slot, holes made with a good plier-type punch. Add a piece of aluminum foil for a windscreen.
pot support alone.jpg pot with support.jpg
The Five Basic Principles of Going Lighter ~ Cam "Swami" Honan of OZ
Here's my set up. Made with 1/2" hardware cloth and aluminum foil. The dish under the stove is cut from a small foil pie pan - it keeps small spills contained, works as a pre-heater if necessary. The stand is less than one ounce. Stove, stand and pot (MSR .9L Titan Kettle) altogether is 6 ounces.
I also used the hardware cloth circle as a stand with mine. For a windscreen I used aluminum from one of those oven liners (it's thicker than foil). It was fastened together with two paper clips (remember to bring a couple of spares with you), and had some holes punched at the bottom for airflow.
For storage, I wrapped the windscreen around the PETE bottle that I used for transporting the fuel.
I have used the Cadara cone to a level of success against wind.
I also used hardware cloth for the stand and aluminum foil for the windscreen. I had both materials on hand so cost was nil. The welds in the hardware cloth will eventually fail but it will last a full season of heavy use. Foil needs to be replaced monthly under the same use.
I use an Olicamp XTS pot. A simple cylinder od Aluminum flashing is the stand/windscreen. Air hole are only at the bottom. Heat is forced through the heat exchangers in the pot. Not UL, but very powerful and efficient when use with a DIY eCHS stove.
The Sterno Inferno pot also works super well, like the Olicamp. Just use the windscreen and pot, replace the lid with foil or a lid from Dutchware: https://dutchwaregear.com/product/imusa-pot-lids/
It might be an ounce penalty, but rock solid.